Mouse Droid MSE-6-5C4883R5: Fitting Toy Car
Still gotta figure out that extender situation with the JADA car. (I was running short on PLA so I had to lay off prints liable to fail.)
Still gotta figure out that extender situation with the JADA car. (I was running short on PLA so I had to lay off prints liable to fail.)
Progress so far... Shells trimmed, mistakes repaired. Wooden frame made, still need the frame spacer. Got the Upper shell primed and 1st coat. Soldered left side PCB. Simple Greebles printed;…
Using Apoxie Sculpt on the nicks, it did wonders on some R2 D2 fiberglass feet. Hopefully it will hold and sand up plum.The stuff functions like bondo, squadron green or…
Got the shell flush-cut.I used a 1/2" tall plywood frame, bolstered by 3/32" balsa or basewood to yield an approximate .1" lip once the frame is reinstalled. Putting a 1/2"…